Steel Ejector Bushing, 2.177 in Outside Dia

This Steel Ejector Bushing has an outside diameter of 2.177 inches. This dimension specifies the outer diameter of the bushing, which is important for its fit within a mold or die. It is typically used in injection molding and die casting to guide ejector pins.

Specifications

Outside Diameter	2.177 inch

About bushings & plain bearings

Steel Ejector Bushing, 2.177 in Outside Dia is listed under Bushings & Plain Bearings — bronze, sintered, ptfe-lined and polymer sleeve bearings. Bushings and plain bearings facilitate relative motion between two components, typically a shaft and a housing, by providing a low-friction, wear-resistant interface. Unlike rolling-element bearings, plain bearings operate on a sliding principle, relying on a lubricant film or the inherent lubricity of the bearing material.

Compare this against other bushings & plain bearings, or search the full index for equivalents from other manufacturers.