Flanged Bushing 3/4" ID x 7/8" OD
This Flanged Bushing has an inside diameter of 3/4 inch and an outside diameter of 7/8 inch. These dimensions define the shaft size it accommodates and its outer housing fit. It is typically used to provide a bearing surface and axial location for rotating or oscillating components.
Specifications
| Inside Diameter | 3/4 inch |
|---|---|
| Outside Diameter | 7/8 inch |
About bushings & plain bearings
Flanged Bushing 3/4" ID x 7/8" OD is listed under Bushings & Plain Bearings — bronze, sintered, ptfe-lined and polymer sleeve bearings. Bushings and plain bearings facilitate relative motion between two components, typically a shaft and a housing, by providing a low-friction, wear-resistant interface. Unlike rolling-element bearings, plain bearings operate on a sliding principle, relying on a lubricant film or the inherent lubricity of the bearing material.
Compare this against other bushings & plain bearings, or search the full index for equivalents from other manufacturers.
Where to buy
1 supplier carry this part. Prices are last-seen and change without notice.
-
Zoro distributor · USSee priceView at Zoro →
Others in bushings & plain bearings
Zinc Plated Steel Machine Bushings 1/2" x 1" x 2"
1 supplier
Thrust Bearing: 1" ID, 1-1/2" OD, 1/16" Thick
1 supplier
Machined Excavator Flanged Sleeve Bearing
CHIZHOU TEHCO PRECISION PARTS CO., LTD.
1 supplier
Flanged Bronze Bushing 1/2" ID x 5/8" OD x 3/4" L
1 supplier
Flanged Sleeve Bearing
1 supplier
PTFE-Lined Steel Sleeve Bearing
1 supplier
Plain Bushing Bearing, Closed, ID 0.750 In
Thomson
1 supplier
Self-Lubricating Oilless Sliding Sleeve Bearing Bushing
1 supplier